Plx Wideband O2 Install Yahoo
Plx Wideband Gauge
Can i install a wideband o2 sensor on a normal aspirated car? Firefox was created in. Wideband O2 Sensor (Bosch LSU4.9). Wideband UEGO Sensor with Stainless Manifold Bung Install Kit Bosch LSU 4.2 O2 Sen. View news & video headlines for Tuesday, 22 Sep, 2009 on Reuters.com. Wire the wideband's switched twelve volt signal to a clean switched 12 volt source that does not cycle while the vehicle is cranking. Wire the wideband's ground wire to a clean ground source (battery). You will need to wire your wideband's analog 0-5 volt output to the input you selected to use on the ecu. Best Answer: Yes. If the motor and transmission is healthy your results should be great. What I mean is if the motor and trans have have proper maintenace and aren't leaking or burning oil. Now on to the turbo. For the money one of the best kits I have seen and used has been Greddy. Great for factory.
Plx Wideband Calibration
Have been using my Kpro on a UK EP3 with a stock motor apart from AEM V2 intake. After a bit of tinkering I flashed the tuned dyno map and its really brought the car to life. However I found I wasn't getting A/F readings because Honda only installed a narrowband o2 sensor!
Thus I'm now the proud owner of a PLX DM-6. However I'm a little confused as to the installation. Is there an idiot's guide as I'm not 100% as to what I need to do. I've spent a few hours researching it but its not crystal clear to be honest. Any help would be appreciated and I look forward to posting some KALs and datalogs once all is working:).
